I am not going to turn down my mesh settings for one airport. I paid a lot of money to have the Pilot's mesh, which is 1m in North America. Am I to understand that you cannot use 1m mesh setting or else you get insane bumps on the taxiway? That's ridiculous. OK, I just finished reading the rest of the posts on here. Where I noticed a difference in mesh settings was in load times. It was cool how I could briefly see there was a serious gully between the taxiways and not just a flat surface like every other airport.īTW, for those discussing mesh settings. I am about to begin a scenario on the ground at KBWI so I can finally see the scenery I paid for. I am running P3D v4.3 and otherwise have absolutely no issues with it. I clearly have the latest version from SimMarket. The second time I landed was at night and this time I saw the bumps clearly with my taxi lights on and it was impossible to steer around them. It just kept bouncing around and displaying stars. I saw some silly graphics of stylized stars exploding on a brownish background and could never recover to any normal view. The first time I came off the runway after landing I must have hit one of these and it ended my flight right then and there. When I VERY slowly run into them my entire plane jumps as if I just hit a boulder at 50mph. The bumps are right on the centerline of taxiways N and S close to gate D34. My mesh is and has always been set at 1m because I have a fast system and I have Pilot's FS Global Ultimate Next Generation mesh installed. I just bought LatinVFR KBWI version 1.1 two days ago (September 3, 2018) and I am having the bumps in the taxiway issue.
0 kommentar(er)
